Dimensional Measuring Interface
Standard
Standard Improvement Request
|
SIR No. 96-7 DMIS Release 3.0 SIR Type Enhancement Severity Prevents Programming Status Resolved Date Submitted November 4 1996 Date Validated November 4 1996 Date In Process August 19 1998 Date Referred Date Vote Pending Date Closed August 21 1998 Action Clarifications Submitted By M.K. Holloway Lockheed Martin Energy Systems P.O. Box 2009 Oak ridge TN 37831 USA Phone: (423)574-6756 Fax: (423)574-2328 hollowaymk@ornl.gov |
Problem Topic
TOL/DIAM: Min/max value
Problem Description
A method of specifying the maximum or minimum value be tested by some tolerances such as TOL/DIAM and TOL/RAD is needed. Cannot specify a maximum or minimum on certain tolderance types.
References
None
Related SIRs
None
Suggested Resolution
Allow the use of the minor words MAX and MIN in TOL/DIAM and TOL/RAD STATEMENTS. These could be options with AVG.
Support Documentation
None
Resolution
Warning!!
The following statement is only a resolution to a Standard Improvement Request (SIR) and is NOT part of the current DMIS standard, nor is it guaranteed to become part of the next revision of the DMIS standard even if voted and accepted by the DMIS National Standards Committee. This resolution is tentative because it may not be incorporated into the next version of the standard, it could be changed prior to the next release, or it could be changed as the result of the "public review and comment" period required for the next version of the standard. If you choose to use this tentative resolution, you do so at your own risk since at this time it is not part of the DMIS standard.
Modified TOL/DIAM, TOL/RAD, TOL/WIDTH to provide ability to tolerance and output tolerances of size using all points on a feature instead of just the substitute feature.
See attached file.
Attachments
96-7_TOL_DIAM_MINMAX.DOC (20.0 KB)
MS Word 97 with SIZE MinMax
Notes
Added by Administrator, bsquier@dmisstandard.com on 6/9/1998
This SIR was designated by committee as "Return to Sender" for further information and explanation; i.e., "unable to understand SIR, is this for single or multiple features? Provide syntax and examples.
Added by Curtis Brown, cbrown@kcp.com on 7/27/1998
I would suggest that we add the options MAX and MIN to var_2.
MAX - signifies maximum diameter for the feature. MIN - signifies minimum diameter for the feature.
Added by Mike Holloway, hkm@ornl.gov on 7/30/1998
The meeting notes from Gaithersburg on 4/10/97 contains marked up pages for this SIR in appendix K.