Dimensional Measuring Interface
Standard
Standard Improvement Request
|
SIR No. 97-55 DMIS Release SIR Type Error Severity Annoyance Status Resolved Date Submitted August 13 1997 Date Validated August 13 1997 Date In Process Date Referred Date Vote Pending Date Closed August 20 1998 Action Insignificant Changes Submitted By Thomas Kramer NIST Room B-124, Bldg. 220 Gaithersburg MD 20899 USA Phone: (301)975-3518 Fax: (301)990-9688 kramer@cme.nist.gov |
Problem Topic
TOL/POS: Obsolete text
Problem Description
Page 93, last two lines:
These lines reference "var_7" and "section 5.9". There is no var_7 in the description and there is no section 5.9.
These two lines look like obsolete lines left over from an earlier version of the DMIS standard.
References
None
Related SIRs
None
Suggested Resolution
Delete the two lines or rewrite them to reference the correct items.
Support Documentation
None
Resolution
Warning!!
The following statement is only a resolution to a Standard Improvement Request (SIR) and is NOT part of the current DMIS standard, nor is it guaranteed to become part of the next revision of the DMIS standard even if voted and accepted by the DMIS National Standards Committee. This resolution is tentative because it may not be incorporated into the next version of the standard, it could be changed prior to the next release, or it could be changed as the result of the "public review and comment" period required for the next version of the standard. If you choose to use this tentative resolution, you do so at your own risk since at this time it is not part of the DMIS standard.
Modify text in TOL/POS.
Modify last sentence in TOL/POS p.93 to:
The existence of var_6 signifies that the tolerance is to be evaluated as a bidirectional positional tolerance per ASME Y14.5M-1994, Section 5.9."
Attachments
None
Notes
Added by DNSC, rui@ornl.gov on 8/7/1998
Change to "per ASME Y14.5M-1994, section 5.9."